After searching endlessly in the forums, I am stumped. I recently replace all pads and sensors with the car along with the FL axle assembly. After putting the car back together, the ABS/DSC/TPMS lights are aglow. I tried resetting the ABS light by pulling the fuse.. No luck. I also tested all of the ABS sensors with my multimeter and have not been able to get any kind of reading from them, all sensors read O.L or open( meter is in resistance setting and touched MM leads to each pin leading to the sensor)
I'm ready to throw the towel and take the car over to the stealer to have them diagnose the fault...I really hate to do that though.
Any

 

Try unplugging the battery for about 5-10 minutes and see if it resets.

 

Disconnected battery... Lights still on