R50/53 Flashing LED
Joined: Jan 2003
Posts: 1,150
Likes: 2
From: Burlington, New Jersey, USA
Flashing LED
I have a 2005 MCS
So I replaced the interior lights with LEDs.
Well almost.
The LED in the boot strobes when the headlights are on. It behaves properly when the headlights are off. I took it out and replaced the old bulb till I can figure out the problem.
Also, How does the map light fixture come off. The one next to the rear view mirror. It has the Air Bag indicator in it.
Any help would be appreciated.
So I replaced the interior lights with LEDs.
Well almost. The LED in the boot strobes when the headlights are on. It behaves properly when the headlights are off. I took it out and replaced the old bulb till I can figure out the problem.

Also, How does the map light fixture come off. The one next to the rear view mirror. It has the Air Bag indicator in it.
Any help would be appreciated.
The lighting circuit sometimes carries a small amount of electricity even when the bulb is supposed to be off. It is not enough power to light a standard bulb, but LEDs require so little power that they may light up. You can remedy this by installing a resistor in parallel with the LED bulb. This provides an extra path for the electricity to leak through and prevents the LED from getting enough power to flicker. People have had success with a 1K ohm resistor.
For the map light, I believe you push the unit towards the front of the car and lever out at the rear edge.
For the map light, I believe you push the unit towards the front of the car and lever out at the rear edge.
Thread
Thread Starter
Forum
Replies
Last Post
ECSTuning
Vendor Announcements
0
Oct 1, 2015 12:13 PM
ECSTuning
Interior/Exterior Products
0
Sep 30, 2015 11:39 AM
ECSTuning
Vendor Classifieds
0
Sep 30, 2015 11:38 AM
ECSTuning
Interior/Exterior Products
0
Sep 30, 2015 11:25 AM
ECSTuning
Vendor Announcements
0
Sep 29, 2015 12:11 PM




