Category: Suspension
Price: $0
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): R55, R56, R57, R58, R59
Location (Region): SoCal
Item Condition: Used

SOLD! a used NM Engineering strut tower tie bar for Gen2 models R55-R59. It's finished in a stippled (non-gloss) red; I don't know if that is original or if it was done before I got it. I picked it up second-hand, and there are a few small spots on the underside of the bar where the finish has been worn off by chafing from vacuum lines. I've shown these in a photo with a quarter so that you can judge the size. Comes with mounting plates, hardware, and instructions. NOTE: This bar fits on turbo MINIs, but doesn't clear the airbox on the normally-aspirated Coopers - or at least not on my 2015 R59 with the N16; I can't speak for the earlier Coopers with the N12 engine, but NM doesn't show that this fits Coopers -- only the Cooper S and JCW. It will fit a JCW with the N18 engine. SOLD, thank you!

 

I'd like to buy your strut tower brace

 

Sold, thanks!