Hello I was wondering is there a JCW pulley remover out there?
I can't seem to find one..

 

anyone? bump.

 

I don't recall there being one.

Why are you looking for a JCW one?

 

cuz I want to take the one off my GP and put a small one. :D

 

regular pulley removal tool, no JCW tool

rentable at your local auto parts store

 

When they put on JCW kits, they replace the entire supercharger, thus, no need for a factory tool!

 

I have talked to Mini-madness and they have Pulley remover but you have to buy from there the pulley. After using the pulley remover you have to send it back ot the company

 

Yep - can be done with a plain-ole claw-type pulley remover. Most likely will destroy the pulley in the process.

 

You can cut down one of the cheap aluminum mini puller types to close up the gap. Some pulleys are really on tight, yet others require very little force. I was able to remove a JCW with the cut down trick! The puller should still work with some longer bolts for the stock size. Just be careful that all force is applied between the front end of the shaft and the pulley itself. At no time should any force be applied between the pulley and the supercharger aluminum body or any side to side pressure anywhere!! It has to come straight off from the pressure to the tip of the shaft by the center screw of the puller. If you muck it up with a 3 jaw pulley puller you can drill and tap the pulley for some some 5/16 bolts and a suiteable puller.