Description:

Back by demand  !
I have a ported facelift supercharger off an all stock 66k mile engine , no rotor damage or flaking and I changed the oil on both ends with full synthetic. 
not only do I fully port out the items , the big difference comes from how I reshape the air paths and allow much much better flow. I also correct the intake manifold cylinder #1 lean condition which the oem setup causes.
after porting I hand sand and then sand blast the insides to smoothen them out too so its almost like a polishing. I then fully clean everything and paint the stuff with a hightemp antiheat paint to help keep underhood temps down AND give the engine a custom look.
Add a 17% or what i would run a 19% supercharger pulley to top it off and you can expect some awesome gains.
im ALSO including a set of convertible support braces with hardware and they're in awesome condition.  I also am tossing in 2x good map sensors and a like new set of intercooler boots and clamps.
I've sold NUMEROUS of these sets now and not once has anyone had anything bad to say.
​​​​i will upload more pics tomorrow showing bbefr and after port n' polishing job.
750$ shipped to lower 48. I will trade for stuff for my 2011 r58 jcw like brembo or willwood rear brakes , aftermarket cam , ported cylinder head , cae or coolerworx shifter , 17-18In namebrand rims ( rpf1  rotiform,  workectect ) paypal is preferred. 
pm or respond to this post. 
if you can pick the stuff up i can sell it for 900$.
Stay safe N MOD on  !!!!!!!