Interior/Exterior Front bumper cover not lined up after changing to Aero Grille
Thread Starter
|
2nd Gear
Joined: Aug 2005
Posts: 54
Likes: 0
From: Peachtree City, GA
Front bumper cover not lined up after changing to Aero Grille
I finished up putting the Aero Grille on the stock MCS grille. When I put the bumper back on, it did not line up properly. As you look at the front of the car, there is a slight gap on the right hand side - maybe 1/2 an inch, and on the right, the edge is pulled in too far. I tried adjusting the 2 bolts in the wheel wells and loosening off all the bolts/screws and re-aligning without success.
Anyone have any ideas?
Thanks!
Robin.
Anyone have any ideas?
Thanks!
Robin.
6th Gear
Joined: Apr 2005
Posts: 4,431
Likes: 0
From: Boerne/SAtown TX
ok, you are on the correct spot, those 2 bolts should be out of line. In other words, you need to adjust them.
Originally Posted by rwalkerphl
I finished up putting the Aero Grille on the stock MCS grille. When I put the bumper back on, it did not line up properly. As you look at the front of the car, there is a slight gap on the right hand side - maybe 1/2 an inch, and on the right, the edge is pulled in too far. I tried adjusting the 2 bolts in the wheel wells and loosening off all the bolts/screws and re-aligning without success.
Anyone have any ideas?
Thanks!
Robin.
Anyone have any ideas?
Thanks!
Robin.
Thread
Thread Starter
Forum
Replies
Last Post
igzekyativ
MINIs & Minis for Sale
34
Jul 16, 2020 12:54 PM
JHolland
R56 :: Hatch Talk (2007+)
1
Aug 13, 2015 10:47 PM