I picked up my "Alice", yesterday from Speedware Motorsports. They performed the pulley & exhaust swap and said that both installs went flawlessly. I specifically asked the mechanic about the quality of the M7 pulley. He said that it was one of the nicest & easiest that he's installed.

He also claimed that it pulls like no other Cooper that he has test driven.

Thanks, Peter and the M7 gang. You truly do think Outside-of-the-Box

 

This is amazing! I cannot stop GRINNING ! ! !

 

I see in your sig that you also have the M7 AGS. Did you get the M7 throttle body as well? If so did you put it on separately or at the same time, and have you found it worthwhile? Also, do you have an enhanced software map like the MTH?

I'm still zeroing in on the mods I'm going to do. I have the MTH software already. I'm thinking of doing the M7 AGS, throttle body and small pulley next as a group. After that I'm torn between larger injectors or larger intercooler or the Milltek cat-back exhaust. So many options, so little disposable income...

 

I jumped the gun on my sig. The AGS with Throttle Body & Heat Shield will not arrive at Speedware until Tuesday, so I had them install the Pulley & Milltek as a separate install and the AGS will go on next week.