Greetings from SO-FLA,

Here a few snaps of my 2016 CMS. My Sony A5100 was out of battery so I only used my iphone and could not take very "artistic" shots, lol....

Drive Safe & Drive Often. Rubber Side Down. Over & Out.

 

Looks very nice, well done, the tint looks really good with the A B C D pillars and on the Light White/

 

First time Mini owner, true blue with black top and wheels.

 

Like the true blue , the black wheels and roof set it off.

 

Took the Countryman touring through wine country today.

 

Just picked her up Friday night.

 

That's awesome. Countryman / Dog best picture.

 

Hey All,

Just thought i would share an update...

2016 JCW Contryman

Just installed...

Megan Coilovers
SPC LCA's
Way Sway Bar (22mm)
Alignment (in progress at Mini of San Diego)
Roof Rack

This is the photo sent by Aaron (Service Advisor)




Brett

 

Looks very nice , I love it

 

Luv the stance. If you don't mind me asking, what did your dealer charge for
You for the install.

 

it ended up being 1350.00 because I had them install some other parts also. Could have had it done cheaper but they are warranteeing everything. I figured I would have piece of mind if anything doesn't feel right, they will adjust and correct.





Just enough to to remove ugly fender gap. Loving the ride too.






Painted headlight washer nozzle covers... Also have the painted rings and painted taillight rings (all done by Mark at Collision Specialties, Inc.). Just send them to him and he sends back in a few days and the finish is AMAZING. Still debating on when/if I will install depending on how they look with stripes.


Brett

 

 

Nice plates! Nice looking car too.

 

That JCW R60 is a beauty!

 

Looks great. Get some springs and lower it.

 

Magenta CM JCW

 

Here you go.

 

+1 and the plates. VERY NICE.

 

My new to me '12 ALL4, just added the 20" Rigid SR light bar this past weekend.

 

Ok... Seriously??? No other info? Which one is it (length that fits so perfectly) and how does the mounting and switch work? It looks absolutely amazing and that is something I would like more pictures (top/back). Did you do the install? Difficulty?

Thanks in advance and it looks really good. Could have been a stock option...

Brett

 

Original post did have some details. 20" Rigid SR, mounted to metal bumper plate, had to trim the lower scoop insert, and I have not yet run the wiring for it.

Took me 8+ hours of work checking and rechecking a million times. Had to make my own steel brackets.

 

Difficulty is high, ingenuity is high as well, as is list of required tools (dremel, large workbench vice, grinder/cutter, foam tape, etc.)

 

Average Joe will struggle, this is my 5th custom LED mounting job on cars/trucks, still takes me forever each time.

 

Wow... There is no way I am ready for this type of project. It looks really good and I admire the effort it took. Good luck with the rest of the project.

 

I wasn't aware of what I was getting myself into when I took that bumper off, but at that point I said screw it, go for it. 2hr job turned into a weekend job. Most of the time was taken up by rechecking everything a million times. And bending, torching, and grinding the steel brackets I made.