New guy old car 1961 Austin Mini 850
#1
New guy old car 1961 Austin Mini 850
Hello I'm Howard Morris , live in Northeast Ohio and I'm the president of the Northeast Ohio Austin Healey Club. I own a 1961 Austin Healey BT7 Tri-Carb Rally replica Tribute car. I just purchased a 1961 Austin Mini Cooper 850 cc. All I have to do now is reassemble it .
Looking for the following
1. Wiring Harness
2. Center speedometer Housing pod (www.rhinofabrications.com) they have a repop for $64.00 anyone have an original to sell?
3. Blank keys for vintage Mini's
Cheers
Any help . comments, would be appreciated
Howard Morris akronzips@aol.com
President NEOAHC
Looking for the following
1. Wiring Harness
2. Center speedometer Housing pod (www.rhinofabrications.com) they have a repop for $64.00 anyone have an original to sell?
3. Blank keys for vintage Mini's
Cheers
Any help . comments, would be appreciated
Howard Morris akronzips@aol.com
President NEOAHC
#2
#3
for keys
http://www.triple-c.com/
caution ... I bought several ignition key blanks from them and took those and my one good key to several locksmiths and each time the new key failed to work
finally saw T-C at a show and had THEM make me copies and those work perfectly . . . . mine was a MK4 however ... you might have better luck
centre pod - 3 dial - http://www.7ent.com/products/instrum...r-14a9815.html
{read the fine print on this part .... it is not the only thing you need - it is the cover and not ALL the cover. You still need trim ring and the supports that go behind to hold the dials . . . }
harness: http://www.7ent.com/products/wiring-...tin-7-321.html
http://www.triple-c.com/
caution ... I bought several ignition key blanks from them and took those and my one good key to several locksmiths and each time the new key failed to work
finally saw T-C at a show and had THEM make me copies and those work perfectly . . . . mine was a MK4 however ... you might have better luck
centre pod - 3 dial - http://www.7ent.com/products/instrum...r-14a9815.html
{read the fine print on this part .... it is not the only thing you need - it is the cover and not ALL the cover. You still need trim ring and the supports that go behind to hold the dials . . . }
harness: http://www.7ent.com/products/wiring-...tin-7-321.html
Last edited by Capt_bj; 04-22-2015 at 01:35 PM.
#4
Thanks BrgPa and Capt BJ
Thanks to both of you for the reply. I'm going to take my tumbler to the next car show swap meet and talk to a vendor. Problem is I don't have a blank key so I may have to buy NOE tumbler and key for this vintage car. I have ordered some lug nuts from 7ent for my mamba mags and have checked Heritage Garage . Good Stuff nice sites. I'll check out nice mini's in NYC.
I found a nice site www.rhinofabrications.com they have the center speedo pods for 64$$$ but are plastic . but look really nice.
Biggest problem I have is that I have no back seat no foam or seat bracket. I did get contacted today by Buddy in Louisville and he says he has a lot of 60-61 parts for an 850.
Thanks for the ideas guys , much appreciated
Cheers
Howard
I found a nice site www.rhinofabrications.com they have the center speedo pods for 64$$$ but are plastic . but look really nice.
Biggest problem I have is that I have no back seat no foam or seat bracket. I did get contacted today by Buddy in Louisville and he says he has a lot of 60-61 parts for an 850.
Thanks for the ideas guys , much appreciated
Cheers
Howard
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
arf88
General MINI Talk
22
05-31-2016 03:07 PM
marendt428
MINIs & Minis for Sale
0
08-08-2015 04:44 AM