any issues with running H&R 19mm rear sway and it touching the stock springs, when its on the full stiff setting?

 

Also anyone have any negative comments about the H&R RSB? i think im going to order one today. promini is running a sale!

 

I have used the H-Sport and Alta bars with no problems.
I have not heard of any problems with the H&R bars. The bushings appear to be good. A couple minor disadvantages is that the H&R bar only has two holes per side instead of three and I could never obtain any spring rate info on the H&R bar. The ProMini price is good.

 

We've seen the H&R's have the bushings rub off the powdercoat and squeak. Save your money and get an Hsport you'll be happier in the long run.

 

My 19mm Mini Mania bar slid to one side and touched the spring after a few months. I centered it and added 2 small hose clamps around the bar at the support clamps to keep it in place. Not too pretty but worked and is unseen.

 

I agree the H-Sport is the best but it is also much more expensive than the H&R on sale. When I purchased my Alta Bar on sale for $110 I just purchased some greaseable bushings from Hotchkis (H-Sport) for $20 and added them to the Alta Bar.

 

I'm on my 5th year of running an H&R 19mm bar on stiff setting with no issues. They come with Teflon bushings that don't use grease and are supposed to be lifetime maintenance free. I wanted an install-and-forget bar and it has proven to be the case so far.