Hello again! I'm replacing the AC Clutch Coil on my R53 and have run into a problem :( The compressor is still attached to the lines and removed from the engine. I've impacted the T30 out of the clutch and taken the outer clutch off. Next, I removed the snap ring, and this is where I am stuck. From every video I watched and tutorial I read, the pulley should just come off and reveal the AC coil. The pulley will spin, but there is no give. I've even tried to tap it off with a rubber mallet, careful to not bend or break anything. I really need to get this thing off, but I am out of ideas.

 

3 jaw puller?