Looking to remove the rear seats in my '11 convert. Thank You.

 

Would think it is similar to my Gen1. Fold the seat down. At the bottom where the two seats meet in the middle there is a pivot point with bolt in it that needs to be removed/loosened. You will then be able to remove the top part of the pivot point so that seat rod will pull out/up.

 

The seat bottom simply lifts off: https://www.newtis.info/tisv2/a/en/r...cility/FZE06wz

For the seat backs, fold them down and detach them from the center hinge. Then fold each side about half way up and you will be able to pull it out of the side hinge: https://www.newtis.info/tisv2/a/en/r...cility/FhG58gd