I’m looking for torque specs for the N14 engine. Is there a comprehensive listing anywhere? I can’t seem to find one anywhere on the internet. I’ve come across some and entered them below but can't find a good reference which lists them all.

Cylinder Head Bolts:
Intake Camshaft Sprocket Bolt: 20NM +180 deg
Exhaust Camshaft Sprocket Bolt: 20NM + 90 deg
Bolts to Attach upper & lower block sections:
Oil Pump drive sprocket bolt:
Connecting Rod Bearing Cap Bolts:
Camshaft bearing cap bolts:
Crankshaft Dampener Bolt: 50NM + 180 deg

I believe that the head bolts, cam sprocket bolts and oil pump sprocket bolt are TTY and should be replaced at every use.

Are there any other critical torques I might need?

 

Haynes online has charts they are in a couple of spots it took me a bit to find them all, they also have some tips that differ from the Bently so its worth it. If I remember correctly the shoulder bolts that locate the timing guide are too high I use a standard metric torque number you can find a chart on line. Be careful with the surfaces of the timing cams and crank shaft sprockets I clean them with alcohol just before so there is no residue

 

Bentley Manual

 

NOT IN THAT BOOK AND IT SUCK don't waste your money if you are going past the valve cover.