R50/53 sanding down surfaces
Thread Starter
|
1st Gear
Joined: Nov 2011
Posts: 19
Likes: 1
From: Ventura County, CA
sanding down surfaces
I took off the supercharger to change the oil in the supercharger. When I went to put it back on, I noticed there wasn't a gasket where the supercharger meets the block. So, do I just sand down the surfaces and pray to God it doesn't leak or .....? Some asstance would be great.
5th Gear
Joined: Oct 2016
Posts: 985
Likes: 97
From: Atlanta Georgia
I took off the supercharger to change the oil in the supercharger. When I went to put it back on, I noticed there wasn't a gasket where the supercharger meets the block. So, do I just sand down the surfaces and pray to God it doesn't leak or .....? Some asstance would be great.
Thread
Thread Starter
Forum
Replies
Last Post