Was wondering if anyone has used this app, bimmercode ?
I see it xan turn off airbag lights supposedly . im going to go test its features out in my r53 in a few hours . im hoping it allows to shut off airbag light then it would be an easy solution for aftermarket seats ...i will report back with my opinion on the app and talk about it's features ..

 

Awe..
.weeeeeeaaaaaaaaak it says r53 armor supported ..

 

I was just looking at the app to see if it could take care of a few problems that I have, it says R53's are not supported, you're says that it does?

 

I think "armor" was supposed to be "are not."

 

It auto corrected . according to the site r53 are not supported BUT as soon as it's above freezing and not blowing 30mph I will run out to my garage and just try it anyways since I already have a dongle

 

Airbag module can be recoded with NCS Expert , you can recode as Inactive both side airbags.After that you must clear fault code with a diag tool.Also you can cheat the airbag module with a 2,3Ohm resistor pluged in wiring socket of airbag seat.