HOW toReplace the hold system when you have a up-grade versi

Oct 11, 2003 | 11:41 PM

Donald

Thread Starter

Neutral

I been read a lot of forums talking about how to change the radio, cd charger..etc
but one thing it seem not too much people talking about is the H/K AMP which sitting inside the rear right plastic panel. I try to change the hold system include HU, front and rear speaker, add amp and sub, I already wrote down all the points for DIY but one thing always bother me is H/K AMP.

Is there any body have such kind of experience please answer my few question:

1, How can I keep the stock wire for new speaker(F and R)?

I try to skip re-wire the speaker cable especially for the front door, it more easy to run with the old wire system, but since I take out the H/K AMP the connection will cut off right there, so to re-connect.

2. Can I remain this H/K AMP and work with the aftermarket HU?

I think..........Not, due to the digital signal communication. If I was wrong please point it out.

3. It cut off this AMP will bother the electrical system of your car?

4, Is there anyone switch the speaker cable while replaced the speaker? How..

Thanks for any respond.

Donald

Reply 0