Drivetrain R53 - advanced chiptuning
Thread Starter
|
1st Gear
Joined: Nov 2022
Posts: 28
Likes: 15
R53 - advanced chiptuning
Hi All, who is the best to do the more advanced chiptuning on the ems2000 and ems5150?
A bit of context, I have been remapping for nearly 20 years by now - I started with Bosch EDC15C2 and moved my way through EDC16, MED17 and now I have started looking at EMS2000 and EMS5150.
One "urgent" question - the ems2000 and 5150 uses the same 29F400 flash as the old Bosch EDC15. I used to do "double programs" on those by using a 29F800 flash and toggling the address pin - effectively giving me to completely different programs. Since the R53 is drive by wire, you can make an inspection friendly map with standard power (as you will not allow the throttle to open very much) or you could do launch control enabled/disabled or you could.. only imagination sets the limits.
So has anyone ever done it on the ems? (Adriancl?)
A bit of context, I have been remapping for nearly 20 years by now - I started with Bosch EDC15C2 and moved my way through EDC16, MED17 and now I have started looking at EMS2000 and EMS5150.
One "urgent" question - the ems2000 and 5150 uses the same 29F400 flash as the old Bosch EDC15. I used to do "double programs" on those by using a 29F800 flash and toggling the address pin - effectively giving me to completely different programs. Since the R53 is drive by wire, you can make an inspection friendly map with standard power (as you will not allow the throttle to open very much) or you could do launch control enabled/disabled or you could.. only imagination sets the limits.
So has anyone ever done it on the ems? (Adriancl?)
Thread
Thread Starter
Forum
Replies
Last Post