Key programing
Thread Starter
|
1st Gear
Joined: Sep 2013
Posts: 17
Likes: 0
Key programing
06 R52 car
Bought a after market key with transponder chip and circuit board
Installed it in an exiting cut key I had
Works the doors,
Only works ignition when:
I insert the working key and turn the key 4X to on position
then immediately insert the "new" after market key
Turns engine on every time
Problem: If it is removed from the ignition, it stops working in the ignition
ANY ADVICE PLEASE?
Thanks
Bru
Bought a after market key with transponder chip and circuit board
Installed it in an exiting cut key I had
Works the doors,
Only works ignition when:
I insert the working key and turn the key 4X to on position
then immediately insert the "new" after market key
Turns engine on every time
Problem: If it is removed from the ignition, it stops working in the ignition
ANY ADVICE PLEASE?
Thanks
Bru
Thread
Thread Starter
Forum
Replies
Last Post
peanut_man
Electrical
5
Sep 9, 2010 05:48 PM