Hi motorers!

Shopping for front and rear carbon fiber emblems to complete my little black-out project on my F60... Still have to receive the OEM front grill!

Anyone knows if the R60 emblems were the same size as the F60?

Thanks!

 

I had never paid attention but since they are side by side in the garage I went and looked.

R60 hood and F60 front and rear all measure the same size at 6 inches across the wings and look essentially the same. Now mounts may be diffrent I don’t have a clue.

The rear on the R60 is 2x bigger and has the rear hatch opening trip built in.
My R 60 front emblem is coming loose and the wings are up on it.

 

Thanks!! Much appreciated.

Care to post a picture of both Countryman sitting side by side in your garage? 😛🤗

 

I want do put the same ones on mine. If you're looking at the outmotoring ones, post back to let us know if they fit!

 

I got them from eBay...

Outmotoring is killing me with duty fees so I try to order from other sites when possible...

 

I see. I need to go measure the emblems front and back to see if they're the same as what is available...

 

R60 and F60 in the Garage with the required back up and deep snow Xterra in the 3rd bay and John Deere on the end.

 

Very nice setup!!

which one is yours? 🤗

 

Got the 6" carbon emblems for both front and rear. Fit perfect.

 

Lucy the Silver and Red is my normal driver. I take Ethel a couple of days a week if the spouse stays home for the day.

 

Nice, which ones (from where) did you go with?

 

I went with ebay since it was cheaper.

 

I'll probably do that too but can't seem to find one for the new Countryman.

 

I recently order the LCI emblem overlays for my 2019 Mini Countryman and I had to order 2 kits because the Bonnet and the Boot overlay is the same size. they sent me a slightly smaller one in both kits I ordered. Does anyone know what the smaller one would fit? I have attached an image so yo can see what I am talking about.

 

I like the newer design black badges, but some people like the older chrome.

https://www.ecstuning.com/Mini-2018-...terior/Emblem/