Airbox STL
For SaleEngine - Intake/Fuel
-
Price
$50
- Location Pittsboro, NC, 27330, USA
- Condition New
- Compatibility
| Make | Model | Year |
|---|---|---|
| Mini | R53: "Mk I" Mini Cooper S | 2002 - 2007 |
Description:
R53 mini cooper airbox. Designed for a 3.5" ID air filter.
if your in NC I can print these, the cults3d link at the bottom is for purchasing the STL for printing
I used a injen X-1021-BB 3.50" Flange ID, 6" Base / 6.875" Media Height / 5.350" Inertia Top https://injen.com/i-30497685-injen-technology-supernano... a filter with a 3.5" ID flange, 5" base and 4" top should be enough
the airbox is similar to a JCW box without the rear noise port.
v3 update, tapered the rear to fit cars that have the plastic partition around the master cylinder. also added tabs on the back to hook onto the lower airbox section
also included my original prototype from many years ago, has a rear port that prints separately (glue together) I use tape on door foam seal on the back side to bump up against the factory plastic partition, drill a hole in the partition.
https://cults3d.com/en/3d-model/various/r53-airbox
I also dont recommend anything that would expose the intake to hot air. I used to run a box that was mostly open, it sounded cool but but temps were too high these eatons dont like hot air, and they dont like any kind of air restriction at all. I also sell a larger snorkle to the radiator shroud I run that with this sealed box on my wifes car. My car retains it's JCW box minus the internal parts and the capacitor thing that fails.
$75 USD + shipping is a modest price to ask for, IMO.
Keeping this ad bookmarked as finances allow (I've just spent another $600 on suspension upgrades to my Mini).
Hoping there much interest for you to get these into production. Best of luck with the sales!