JCW Rear Headrest Positioning
#1
Rear Headrest Positioning
Saw the interior 'rear seat' photo of a 2016 'S' Convertible
and noticed the head rests sat much lower than mine are
able to be positioned. There is a mid-way 'stop point' that
doesn't allow the metal rods to disappear from view, as is
the case in the 2016 'S'. I'm able to remove the head rests
quite easily by activating the plastic 'press release' button
on each of them but lowering them when reinstalled can only
be to the standard mid-way position. Any way to over-ride
the 'stop points'?
After posting above I realized that the two plastic discs in the
center of the rods can be easily removed once you push the
small pin through and out. Now I have no problem lowering
them all the way to the top of the backrest.
and noticed the head rests sat much lower than mine are
able to be positioned. There is a mid-way 'stop point' that
doesn't allow the metal rods to disappear from view, as is
the case in the 2016 'S'. I'm able to remove the head rests
quite easily by activating the plastic 'press release' button
on each of them but lowering them when reinstalled can only
be to the standard mid-way position. Any way to over-ride
the 'stop points'?
After posting above I realized that the two plastic discs in the
center of the rods can be easily removed once you push the
small pin through and out. Now I have no problem lowering
them all the way to the top of the backrest.
Last edited by ridgemanron; 11-12-2017 at 06:06 AM.
The following users liked this post:
CooperT (12-26-2017)
#3
Thread
Thread Starter
Forum
Replies
Last Post
jiggersplat
R57 :: Cabrio Talk (2009+)
3
12-13-2018 01:43 PM