I purchased the rear fog light kit from Outmotoring.com and I cannot figure out how to pop out the section of the bumper where the fog lights go into. I can clearly see the cutouts for where the fog lights go. I felt underneath the bumper around that area and could not feel any clips or anything holding the inserts in place. How do I get those two sections of the bumper out so I can insert the rear fogs in their place? Please help.

 

there are plasitc releases on each end of the plastic cover, its easier to see this from under the car.

 

Good thing I looked on here. I was thinking (without looking) that it was one piece and I was going to have to dremel it out. Took 1 minute each light....Thanks.