Hey guys!

Before I go on a wild goose hunt looking for the FRONT o2 sensor signal wire (green wire on the sensor side) on the wiring loom in and around the dash area, has anyone located it before? I am installing an Air/Fuel Ratio meter by the steering column/speedo and need to tap the wire for the signal. Meter wires are notoriously small (think 18-22 gauge) and short so would prefer tapping it somewhere near the ECU vs trying to extend the wiring in the simple harness plus deal with heat protection of the wire.

 

After a bit of contemplation, I decided not to tap the factory o2 and potentially interfere with the ECU o2 signal even though I know how to do so without making a mess of it. Instead, I decide to purchase an Evolution Racewerks 304 SS mandrel bend DP w/ 200 cell cat, 2K degree ceramic coating + bungs for EGT & WBO2 sensors :D. I will soon be writing this all up in my build thread.