Picked up a used NM Engineering power module and after about two months of use my 2022 F55 S is getting a 101F01 code(throttle valve angle - absolute pressure intake manifold, comparison: pressure too high).

Took the module off and cleared the code and it never came back on. Put the module on again and immediately the CEL turned on after 5km of hard driving. Not sure what to do because Neuspeed's customer support is terrible and they seem less keen on helping out knowing im not the original buyer of the device.

 

Nothing new.
All these modules eventually fail.
NM, Burger JB+, Dinan. They will only warranty original purchaser.