Hey guys.
I'm replacing my SC and need to swap over the WMW 15% pulley.
Anyone know how to get it off?

This is the one I have.
http://www.waymotorworks.com/15-supe...ulley-wmw.html

Thanx!
Dan

 

Just remove the bolts...
Many folks use a bit of locktite© on them to make sure they don't loosen...if this is the case, a bit of heat will soften it, letting you remove them.

 

The 2 halves were stuck together.

Remove all 4 bolts.
2 of the holes on the outer part are threaded. Not the holes used for clamping the 2 pieces.
Take 2 long m5 bolts, bottom the 2 bolts out and a couple of turns and the 2 parts separated.

Easy

Thanx for the reply!