North American Motoring
Share Your Pictures with Our Community. Upload Now
0 2026/05/10 20:25:45
0 2026/05/10 17:40:53
0 2026/05/10 17:29:47
0 2026/05/10 17:05:20
0 2026/05/10 17:05:16
0 2026/05/10 17:05:12
0 2026/05/10 15:31:15
0 2026/05/10 12:12:25
0 2026/05/10 12:12:20
0 2026/05/10 11:08:34
Old
Old
0 2026/05/10 10:34:24
Old
Old
0 2026/05/10 10:34:18
Advertisement
0 2026/05/10 10:34:12
New, known good Diverter Valve
New, known good Diverter Valve
0 2026/05/10 10:34:06
0 2026/05/10 08:07:51
0 2026/05/10 08:07:49
0 2026/05/10 08:07:47
0 2026/05/10 08:02:29
0 2026/05/10 08:01:35
0 2026/05/09 15:26:07
0 2026/05/09 15:26:05
0 2026/05/09 14:57:53
0 2026/05/09 11:17:51
0 2026/05/09 11:16:57
And for good measure, here's the connector/pigtail assembly before splicing it on.
And for good measure, here's the connector/pigtail assembly before splicing it on.
0 2026/05/09 08:53:20
Here's the new connector (after being spliced on) on the new coil. The connector was a very tight fit on the coil and the red locking thing was somewhat difficult to slide across. Keep wiggling the connector on so you can get it completely on the coil and keep wiggling the locking slider until it goes over and looks like this. Otherwise the plug could work back out.
Here's the new connector (after being spliced on) on the new coil. The connector was a very tight fit on the coil and the red locking thing was somewhat difficult to slide across. Keep wiggling the connector on so you can get it completely on the coil and keep wiggling the locking slider until it goes over and looks like this. Otherwise the plug could work back out.
0 2026/05/09 08:49:18
You can see that the connectors are the same.
You can see that the connectors are the same.
0 2026/05/09 08:47:04
Soldered and shrink wrapped. This fits nicely in the heat protective sleeve that goes up to the connector.
Soldered and shrink wrapped. This fits nicely in the heat protective sleeve that goes up to the connector.
0 2026/05/09 08:45:20
Wires cut (about 5 inches back), new connector ready to solder on.
Wires cut (about 5 inches back), new connector ready to solder on.
0 2026/05/09 08:43:16
0 2026/05/09 08:41:35
0 2026/05/09 04:36:08
0 2026/05/08 21:26:23
Advertisement