Front caliper rebuilt
2 Attachment(s)
Good morning all,
So I actually have a R53 but I am doing the R56 fronts caliper on the R53 mod. I picked up a set of calipers and am in the process of rebuilding and powder coating them. When I removed one of the slide pins, the plastic stayed behind in the caliper. I did get it out, but the plastic is destroyed. I looked online but could not find a replacement but did find replacement pins on ECS. However the pins are not the same as original. See pics and link. New pin link: https://www.dormanproducts.com/p-31163-hw14901.aspx Has anyone used the new pins? Then also because I was an idiot and did not snap a pic at the time, which pin goes where? Does anyone know where / if I can get just the plastic piece? Thanks |
Beuller?
|
No one has done any front brake caliper rebuilds on a R56?
|
moving you to Tires, Wheels, & Brakes, you should get more views and some help here.
|
I have the JCW R56 calipers out and laying on my garage floor but I am over by the Dragon this week. When I get back I will do some digging if you still need the info.
|
Thanks Whine,
I found what I needed. |
Please share ! Someone else will have the same question at some point.
|
After looking at images and forums I found the answers. The caliper pin with the silicon bushing(or whatever) goes into the bottom hole of the caliper carrier and the longer plain pin in the upper. I did find replacement parts that matched the original, not just the Dorman(HW14901) found at some places. Rockauto (https://www.rockauto.com/en/catalog/...boot+kit,11515) had all the part in varies kits. I ended up ordering all the seals, rubber boots and bushing from them and used the old pins.
|
All times are GMT -7. The time now is 08:22 AM. |
© 2024 MH Sub I, LLC dba Internet Brands