Description:

I've sold numerous of these ported setups as they net amazing gains and allow for the safe use of a 19% pulley for street use...
I port out and reshape the air paths in the back side of the supercharger and massively open up the inlet , I do the same to the supercharger hat also and on the intake I port match all 4x opening as well as enlarge the inlet side. i finish it off by media blasting the inside to further smoothen it out and then I sandblast the outsides so they look like new again and give a classy oem look. I ALSO change the oil on both ends of the supercharger with full synthetic..
the supercharger has never had a aftermarket pulley on it and it came off an 07( upgraded face-lift sc with coated rotors), all stock,  automatic ( never seen high rpms ),  female driven engine ( car was never driven hard). Unfortunately the car was rear ended and totalled.. her car had almost 200k but the sc was replaced last year and this SC supposedly had under 100k when put on as a replacement and she put about 15k miles on it.
sorry it took so long to get this up but the face-lift sc's are starting to become abit scarce ,i will have the setup ready in 3x days. 1st come 1st serve because i have had numerous people asking for me to do another set , so here it is !
725$ shipped to lower 48x or 650$ picked up within 50x miles of 53221 , paypal is preferred..
pm or respond to this post. 
unfortunately I no longer have a mini but I would be interested in a trade for 2x small reclining racing seats , or a set of 14in rims preferably jdm styled because i want the stuff for my Suzuki cappuccino. 
i will upload befor and and after pics of my port n polish job soon as im finished. 
stay safe N motor on !!!!!