Not sure if this is the best forum, but I hit some road kill today that took a chunk off my lower aero grill:





Instead of replacing the whole front end, do I have options?

Is there a type of DIY plastic epoxy putty I can form/mold into place, sand down, & then paint w/ a flat black?

 

Well, I just went back on the HWY and found a huge chunk that covers 75% of the break, so that is good. I can just glue that back on.

The other little piece was probably in the coyote, I was not going to go digging for it.

So it looks like I just need to fill a 2"x2" gap.

 

To be completely honest, I'd put my car up on a lift and trim the rest of it off nice and neatly

 

thats the truth... My MINI is so low it used to hit everything. I have since then completely trimmed that piece off of the bumper cover.

 

Same thing here. Took out a wheel arch and that piece. Elected to only replace the arch.

 

The plastic is pretty soft.

I think a large exacto could shave the whole thing off easily.

After sleeping on it, I think I will.. I am sick of it scraping everything.

 

That's the spirit!

(also in the tired of scraping everything club. Also realize it's my own dang fault)