How To HOW TO - Jack up the MINI
#26
Great setup. I normally use my floor jack with a square of 3/4 plywood at the center of the car where the reinforced section on the underside of the car is. I am then able to place my two jack stands under the front and the rear jack pads.
I then repeat for the other side to get the MINI up onto four stands.
Using this method I have never deformed or damaged the underside.
I wish I could post a picture to help my explanation.
Matt
I then repeat for the other side to get the MINI up onto four stands.
Using this method I have never deformed or damaged the underside.
I wish I could post a picture to help my explanation.
Matt
#27
BlimeyCabrio's blog has lots of pictures of how he does things. The page related to this topic is labeled "How a stud lifts a MINI".
http://www.blimeycabrio.com/2007/04/
There's lots of other good stuff on his blog well worth reading.
http://www.blimeycabrio.com/2007/04/
There's lots of other good stuff on his blog well worth reading.
#28
I have the metal for sale. Purchased all the metal tubing for about $110 but never found anyone who could cut and weld it for me. At this point it's just sitting in my garage as I have sold/selling my MINIs. I'll sell it all for $80 (that's two long pieces and the four short pieces). Local pickup only - Northern VA.
https://www.northamericanmotoring.co...ml#post4198039
https://www.northamericanmotoring.co...ml#post4198039
Last edited by igzekyativ; 04-15-2016 at 05:09 AM.
#32
Thread
Thread Starter
Forum
Replies
Last Post
igzekyativ
MINIs & Minis for Sale
34
07-16-2020 12:54 PM
ECSTuning
Vendor Classifieds
0
08-07-2015 05:55 AM
ECSTuning
Interior/Exterior Products
0
08-05-2015 02:11 PM