Oil drain valve?
#28
I bought at Home Depot - in the plumping section they have a selection of plastic and rubber hoses. I just carried the valve in, before installation, and played until I found what fit and then bought a foot. My local ACE also has a selection and I'm so does Lowes. You are just using this for a gravity feed - no pressure - so no worries about strength or 'auto specific' stuff. None of the standard auto brake/fuel/heater stuff I had around was exactly the right size altho the plastic air line I needed to pipe the air horns was close
#29
Capt...
Did you end up buying rubber or plastic tubing?
As you know, I already have it installed, so doing a test fit isn't an option unless I purchase 2" or 3" lengths.
I have a BUNCH of leftover, brand-new silicone tubing that is used for supplying air to fishtank decorations...I guess I'll see if that will work.
At least I'll know if I need to get bigger/smaller tubing...
Nice horn setup, btw.
Did you end up buying rubber or plastic tubing?
As you know, I already have it installed, so doing a test fit isn't an option unless I purchase 2" or 3" lengths.
I have a BUNCH of leftover, brand-new silicone tubing that is used for supplying air to fishtank decorations...I guess I'll see if that will work.
At least I'll know if I need to get bigger/smaller tubing...
Nice horn setup, btw.
Thread
Thread Starter
Forum
Replies
Last Post
igzekyativ
MINIs & Minis for Sale
34
07-16-2020 12:54 PM
Lex2008
R56 :: Hatch Talk (2007+)
0
08-16-2015 08:33 PM