CV axle shaft removal
#1
CV axle shaft removal
Hi,
Has anyone had experience removing the driveshaft / axleshafts from an R60 Countryman with All4?
I might need to remove the right hand front shaft if attempts to repair the thread are unsuccessful!
Im assuming I just need to pry it out of the box (it's already free from the wheel bearing hub assembly) but wanted to double check in case I do some damage!
Cheers
Joe
Has anyone had experience removing the driveshaft / axleshafts from an R60 Countryman with All4?
I might need to remove the right hand front shaft if attempts to repair the thread are unsuccessful!
Im assuming I just need to pry it out of the box (it's already free from the wheel bearing hub assembly) but wanted to double check in case I do some damage!
Cheers
Joe
#2
Once the halfshaft is free from the hub there is a half shaft support near where it goes into the transmisison that will also have to be removed. 4 bolts and it comes off but it's tight working quarters in there. To get the halfshaft out of the transmission I used a long screwdriver and tapped it with a hammer from under the car outward, not many great prying points under there.
The following users liked this post:
JoeyBR60 (12-07-2017)
#3