Drivetrain Manic tune stage 2
#101
10-01-2017, 05:19 AM
JCW or hybrid turbo
Hello everyone.
I would like to have your experienced opinion!
I'm considering to put a JCW or hybrid turbo (just compressor side)
Then, i'll go for a manic tune.
My main goal is to gain better top end power.
Once i´m not considering meth by now, is best to suit lower boost? For example: Map A: 17 psi, Map B: 18 psi....
Any advice is wellcome!
Mini regards.
I would like to have your experienced opinion!
I'm considering to put a JCW or hybrid turbo (just compressor side)
Then, i'll go for a manic tune.
My main goal is to gain better top end power.
Once i´m not considering meth by now, is best to suit lower boost? For example: Map A: 17 psi, Map B: 18 psi....
Any advice is wellcome!
Mini regards.
#102
10-01-2017, 05:59 AM
#103
10-02-2017, 08:29 AM
#104
10-02-2017, 08:34 AM
#105
10-03-2017, 04:09 AM
Hello everyone.
I would like to have your experienced opinion!
I'm considering to put a JCW or hybrid turbo (just compressor side)
Then, i'll go for a manic tune.
My main goal is to gain better top end power.
Once i´m not considering meth by now, is best to suit lower boost? For example: Map A: 17 psi, Map B: 18 psi....
Any advice is wellcome!
Mini regards.
I would like to have your experienced opinion!
I'm considering to put a JCW or hybrid turbo (just compressor side)
Then, i'll go for a manic tune.
My main goal is to gain better top end power.
Once i´m not considering meth by now, is best to suit lower boost? For example: Map A: 17 psi, Map B: 18 psi....
Any advice is wellcome!
Mini regards.
Any advices from those that upgrade the turbo... is recomended to "work" with a little less boost?
I already have 100 cell akrap cat, full 2.5" exhaust, Bigger intercooler, colder plugs...
Thanks on advance!
#106
10-06-2017, 01:22 PM
Well went to my trusted muffler shop, installed a 2.5" pipe from down pipe with a very nice MF resenator now I like to drive the car very deep sound and still have my power...love it before it was 3" straight pipe to muffler I think it was stealing HP. I kinda feel I have a little more pep.
Ben
Ben
Last edited by Bnourai; 10-06-2017 at 01:28 PM.
#107
10-10-2017, 11:58 AM
We have the same setup. I also added the Forge BOV Recirculating. Luv that surberine sound when it releases boost, but I've done my homework on this cause I'm shopping for a new high flow turbo and here's what it comes down to.
If you're looking for top end go with a 47mm or higher HP turbo. They'll take a little longer to spool but the dyno data says you'll have all the top end you need for tracking. The 43mm HP turbo is quick spooling and best suited for folks who want speed quickly and throughout the rpm range. I've decided to go with a JMTC 43mm. Hope this helps.
If you're looking for top end go with a 47mm or higher HP turbo. They'll take a little longer to spool but the dyno data says you'll have all the top end you need for tracking. The 43mm HP turbo is quick spooling and best suited for folks who want speed quickly and throughout the rpm range. I've decided to go with a JMTC 43mm. Hope this helps.
#108
03-31-2018, 04:42 PM
Stage 2 question - Inspection
I'm currently in CO and we don't even have inspections. However, I'm moving to NJ in about 9 months and they are notorious for being strict. Do I have any chance passing with Stage 2? I am currently mod free and I'm trying to figure out if Stage 2 is worth the aggravation or if I should just go with Stage 1 (Intercooler, plugs, ECU) Thanks!
#109
03-31-2018, 05:26 PM
#110
03-31-2018, 06:26 PM
I'm currently in CO and we don't even have inspections. However, I'm moving to NJ in about 9 months and they are notorious for being strict. Do I have any chance passing with Stage 2? I am currently mod free and I'm trying to figure out if Stage 2 is worth the aggravation or if I should just go with Stage 1 (Intercooler, plugs, ECU) Thanks!
Thanks
Mario
mQubed Motorsport RPM Power and Manic Dealer
#111
04-05-2018, 09:33 AM
No one jumped on this one and I was wondering as well 
Thoughts ??!?!
For those of you with a catless downpipe, how have you been passing inspection? I've been told the Manic Stage 2 tune will eliminate the CEL due to the downpipe but will NOT set the OBD catalyst readiness monitor. This is crucial for me as the car will pass visual with the secondary cat but will not pass the scan here in PA for OBD readiness monitors. If this is true I'm considering throwing in the towel and going back to stock because its a pain in the butt to swap out the downpipe annually.
Thoughts ??!?!
#112
04-06-2018, 09:48 AM
No one jumped on this one and I was wondering as well
Thoughts ??!?!
For those of you with a catless downpipe, how have you been passing inspection? I've been told the Manic Stage 2 tune will eliminate the CEL due to the downpipe but will NOT set the OBD catalyst readiness monitor. This is crucial for me as the car will pass visual with the secondary cat but will not pass the scan here in PA for OBD readiness monitors. If this is true I'm considering throwing in the towel and going back to stock because its a pain in the butt to swap out the downpipe annually.
Thoughts ??!?!
mQubed Motorsport, Manic and RPM Power Dealer
#113
11-02-2018, 10:47 AM
Please define how many miles? 20, 50, 80? I just had mine in the stock map and a CEL came on. Cleared it and 2 monitors are not ready. Drove probably 2 miles since then.
#114
11-02-2018, 12:15 PM
Alliance Member
#115
11-04-2018, 06:09 AM
#117
12-04-2018, 11:41 AM
Hi guys/gals. Ok so I just went through this entire thread, and I am admittedly not even close to you guys about this stuff, so I apologize for what I guess is a pretty stupid question, but why is it that all the gen 2’s are able to handle all this power, or potential power, (such as Mario’s post of that incredible 400+ HP turbo upgrade), but the gen 3’s can’t? As you can see I’ve got a ‘16 f56 JCW, and according to all the huge amounts of threads I’ve been through, there seems to be too many ancillary issues that my car simply can’t handle. I mean if you google “turbo upgrades for 2012 MCS” you get about 20 options for 400+ hp gains. What’s the deal here? Again, my apologies for such a “noob” question.
Mike
Mike
Last edited by normtrum; 12-05-2018 at 08:58 AM. Reason: Spelling
#119
01-07-2019, 11:33 AM
#120
03-27-2019, 01:18 PM
Thread
Thread Starter
Forum
Replies
Last Post
Mini Mania
Drivetrain Products
0
08-21-2015 11:25 AM
