Hi guys,

Does somebody already do this ?? I want to do it, here is an example video:

http://www.youtube.com/watch?v=IEQiQ...layer_embedded

But I want to be very very sure before install it, what do you think.

This is my MCS 06:





What do u think ? any ideas ?

thanx in advance!

Mario

 

Thanks for the link to the video.

The headlight rings are easy to remove, so I would take them off to cover them.

Jim

 

I think will be easier to install the 3M product with the rings installed in the headlights, like the video

Or not ??

 

I have never used used that brand, so it may very well be as easy as the video looks. I do know from using other types on my Mini that cleaning is the key to it sticking and staying stuck. I do not see how you can clean well along the edges where you want it to tuck under. Just saying.

Jim

 

Ok I will check it very well, thanx a lot for your comments/recommendations!

 

I did mine while still on the car.. The Di-Noc vinyl is very easy to work with but not cheap... Compared to other vinyl... Search Ebay for a small piece, hand cut it, lay it on, tuck it in and trim off excess...

 

Do it with the rings installed, you will be pulling the vinyl in all directions to get it to lay, make sure you have a good heat gun and take your time. I used Oracal matte black for mine, great product, stretches to about 200%.

 

Thak you so much for your comments, I did it/installed it and here are the results:

 

Very nice! Where did you get the 3m film?

 

Here in Mexico.

 

Looks awesome! I would do it if that guy in the video came with the kit! He's a magician!

 

Heheehehe yes I am agree with you, but also it is not impossible to install it.