Interior/Exterior OEM E92 M3 Rear LEDs fitted
#1
OEM E92 M3 Rear LEDs fitted
First up I took of the rear number plate plinth. Was an easy job as it was just 4 x torx bolts and unclipping the electrical wires. (excuse the piccys used the compact as I couldnt be bothered with the SLR)
car needed a wash hence the dirt.
used these bits, although the bullets werent needed in the end.
Was a very tight fit and had to trim the oem plinth quite a bit and the new lights to get a flush fit.
In the end I managed to do it and wired them up. It didnt work first time but some rewiring later it functioned correctly and the boot popper was working once more.
Siliconed them into place so they fit flush and were water tight...
And volia... sorry didnt have time to wash the car.
far better than the ebay tat!
car needed a wash hence the dirt.
used these bits, although the bullets werent needed in the end.
Was a very tight fit and had to trim the oem plinth quite a bit and the new lights to get a flush fit.
In the end I managed to do it and wired them up. It didnt work first time but some rewiring later it functioned correctly and the boot popper was working once more.
Siliconed them into place so they fit flush and were water tight...
And volia... sorry didnt have time to wash the car.
far better than the ebay tat!
#3
#5
Thread
Thread Starter
Forum
Replies
Last Post
igzekyativ
MINIs & Minis for Sale
34
07-16-2020 12:54 PM