FSP / DSP (Street Prepared) 07 MCS Camber plates
#2
I think the right answer for that right now is "nobody".
Ireland Engineering makes plates for the 2007 cars. But, if you can wait for Helix to get there plates made, I think you should wait.
For the pre-2007 cars, the Helix plates have a much better repuation than the Ireland plates. But, the Helix plates are also much more expensive than the Ireland plates.
Ireland Engineering makes plates for the 2007 cars. But, if you can wait for Helix to get there plates made, I think you should wait.
For the pre-2007 cars, the Helix plates have a much better repuation than the Ireland plates. But, the Helix plates are also much more expensive than the Ireland plates.
#3
A quick update, I installed Ireland Engineering's fixed camber plates. The car is sitting at -1.2 left side and -1.3 right side. At the same time I also ditched the run flats and put Yokohama S-Drives on the car.
The car was fun before, but now it's funner! (I know, that ain't a word!)
I'd highly recommend getting a pair if you're looking for some additional camber.
The car was fun before, but now it's funner! (I know, that ain't a word!)
I'd highly recommend getting a pair if you're looking for some additional camber.
#4
A quick update, I installed Ireland Engineering's fixed camber plates. The car is sitting at -1.2 left side and -1.3 right side. At the same time I also ditched the run flats and put Yokohama S-Drives on the car.
The car was fun before, but now it's funner! (I know, that ain't a word!)
I'd highly recommend getting a pair if you're looking for some additional camber.
The car was fun before, but now it's funner! (I know, that ain't a word!)
I'd highly recommend getting a pair if you're looking for some additional camber.
Thread
Thread Starter
Forum
Replies
Last Post
ebowling
R50/R53 :: Hatch Talk (2002-2006)
90
08-04-2019 09:15 AM
Minibeagle
Stock Problems/Issues
6
08-13-2015 10:00 AM
ClayTaylorNC
R50/R53 :: Hatch Talk (2002-2006)
6
08-10-2015 09:19 PM