F60 Phone Mounting Solutions
#1
#3
#4
My last F 56 had the click and drive already installed loved it my current F54 does not and I do not want to spend the $$$ on it because I feel like it is totally overprized so I was looking at the same mount as one of our members bought I just can not figure out how to install it since they always show them long screws in the picture.
#5
It is actually easy to install. Under the speedometer there are two rubber round covers with a hole in the middle. Take a small screw and insert it in the hole. Turn to make it tight then pull out the plug. Repeat on the other side. Then remove the two screws they covered. At this point the speedo will be loose. Pull it forward. Remove the two screws in the back. Then use the two longer screws they supply to replace them holding the new phone holder in place.
I hope this helps.
I hope this helps.
The following users liked this post:
Evlkarl (01-23-2019)
#6
Here is a link for instructions.
https://www.newtis.info/tisv2/a/en/f...ter/1VnXqusF6v
On a side note, does anyone know how to change the wireless phone charger in the arm rest?
Thanks,
https://www.newtis.info/tisv2/a/en/f...ter/1VnXqusF6v
On a side note, does anyone know how to change the wireless phone charger in the arm rest?
Thanks,
Last edited by Blu_lite; 01-18-2019 at 08:16 AM.
#7
Ooh I like this. Got a link? Thx!
UPDATE!
Saw a video on the CRAVENSPEED Gemini mount. Love it. Bought it.
https://www.cravenspeed.com/gemini-p...ount-for-mini/
Thanks for leading me to my new mount.
UPDATE!
Saw a video on the CRAVENSPEED Gemini mount. Love it. Bought it.
https://www.cravenspeed.com/gemini-p...ount-for-mini/
Thanks for leading me to my new mount.
Last edited by MNCNTRYMN; 01-18-2019 at 08:55 AM.
Trending Topics
#8
#9
#10
Update on the CRAVENSPEED Gemini Mount...
It's fantastic! Only "complaint" would be sometimes the phone would shift on the magnetic mount. Needed to find the sweet spot between the case back and phone (mounted portrait and landscape) to minimize the movement over bumps (alway in SPORT mode).
It's pricey, but solid! Installation took 10-15 minutes and it pretty easy as long as you're careful removing the 3 electrical plugs when pressing the tabs and you don't over-tighten the new screws that come with the mount. Apparently the threads behind the tachometer are plastic.
Hope this helps anyone considering this mount.
Cheers!
It's fantastic! Only "complaint" would be sometimes the phone would shift on the magnetic mount. Needed to find the sweet spot between the case back and phone (mounted portrait and landscape) to minimize the movement over bumps (alway in SPORT mode).
It's pricey, but solid! Installation took 10-15 minutes and it pretty easy as long as you're careful removing the 3 electrical plugs when pressing the tabs and you don't over-tighten the new screws that come with the mount. Apparently the threads behind the tachometer are plastic.
Hope this helps anyone considering this mount.
Cheers!
#11
It is actually easy to install. Under the speedometer there are two rubber round covers with a hole in the middle. Take a small screw and insert it in the hole. Turn to make it tight then pull out the plug. Repeat on the other side. Then remove the two screws they covered. At this point the speedo will be loose. Pull it forward. Remove the two screws in the back. Then use the two longer screws they supply to replace them holding the new phone holder in place.
#12
Thread
Thread Starter
Forum
Replies
Last Post
GoBadges
Vendor Announcements
0
10-01-2015 11:10 AM
Navigation & Audio Any Suggestions for a Great iPhone Mounting Solutions?
jondell
Navigation & Audio
6
03-22-2010 04:32 PM
Navigation & Audio iPhone mounting solutions in da MINI...
RandomGemini
Navigation & Audio
2
05-25-2008 08:58 PM