Lock/Unlock chirp using fuel door actuator?
 

Anyone figure out a way to add a horn or something to the fuel door actuator so you can get an audible confirmation of lock/unlock? I did this on the previous gen MCS, but I can't seem to find the correct wires on the F56.

That's a good idea. I actually use the fuel door locking as a "chirp" and listen for that to confirm the lock.

i did that too on my '04 using a $10 piezo buzzer from Radio Shack

has anyone figured out how to add this audible alert?
 

so ...... has anyone figured out how to add an audible chirp for when you lock the doors....by accessing the actuator for the gas filler door ?

success !! did it !
 

Success!! ...Did it! ......i was able to follow the wire from the fuel door actuator to access it at an easier place .....if you look at the wires at the rear tail light, coming down from above the assembly, there is one separate cable with a black wire and a blue wire coming down vertically against the back of the car.....the two wires are wrapped in a black cloth-like wrapping ......i first tapped into the blue wire for a positive connection...for the ground just below that is the 5 wire plug that goes into the tail light and the middle wire, brown, is the ground and i tapped into that. I bought a piezo buzzer 12V / 58 ma /100 db at my local Radio Shack which unfortunately ( fortunately for me though) is closing so the buzzer was 80% off so it cost me only about $3.50 ...!

it worked ...BUT ...opposite of what i wanted .....oops ...the buzzer beeps when you unlock the car ....( not as important to me but then again i may go back and get another buzzer to beep for unlocking ) ...... so then I simply disconnected from the blue and stripped the black wire and tapped into that ...success ...the car will beep only when the car is off and closed and then you lock it with the FOB....it does not beep if you are in the car and lock it manually or if you drive off and the car " auto-locks" at 11mph ......

I simply ( with some added length wires) sticky velcro'd the buzzer so it is sitting on a little shelf-like area down below the tail light. The buzzer is noticeable and loud enough, though it could be louder but you can definitely hear it lock now ......loud enough and won't disturb the neighbors

just a quick follow-up ,,,,it has been a couple weeks now since i added the buzzer that goes off upon locking with the FOB (no stock alarm in my car) .....no problems ,,,.....no interference with the car's electronics

Bought my buzzer anxious to try this mod. However I can not find the blue and black wire of which you speak. I have a 2017 2 door hatchback f56. The wires to the locking gas cap do not seem to be accessible. A picture would be appreciated.

hi ...here's a photo but might be kinda hard to picture this but to orient you can see the round piezo buzzer sitting way at the bottom which had 2 short red wires but i spliced on to it 2 white wires ....one white goes up to the thin cable you are look for .....if you look right above the passenger side rear tail light wiring harness there's a black thin cable that is really a black and a blue wire wrapped is black fabric ...this cable come down vertically from above the tail light and is separate from the bigger bundle of wires that comes down too ( which have a couple of browns and a couple of yellows and a bunch of other wires), but the cable you are looking for will be coming down vertically separately and more towards the outside and a bit behind the bigger thicker cable, and eventually gets connected into the bigger bundle ..... i tapped into the black wire that is in the thin cable for power and the for ground if you look at the plug that goes into the tail light there are 5 wires and the other white wire from the buzzer gets tapped into that.......hope this is somewhat helpful!

DANG //the photo got cropped ....the buzzer is out of the photo at the very bottom but you can see the 2 white wires coming up ....the cable you are looking for is ( unfortunately) out of focus at the very top of the photo ...if you follow that this cable along you can see it gets connected to the thick bundle above the tail light

https://cimg2.ibsrv.net/gimg/www.nor...296969b36f.jpg
5 wires and the middle wire is brown which is the ground
wiring of buzzer upon locking

so SCGuy ......did you get it to work?

Did someone got it to work? Any help appreciated on finding the relevant cable to tap into.

https://cimg9.ibsrv.net/gimg/www.nor...716910ba3.jpeg
https://cimg1.ibsrv.net/gimg/www.nor...c5a1285d2.jpeg
https://cimg2.ibsrv.net/gimg/www.nor...41ea4ec08.jpeg

SCGUY did you ever get this to work? Did you find the wire? I have a 2019 F56 JCW and I don’t see a vertical wire with black and blue wires.