Electrical NCSExpert for beginners
#501
#502
Has anyone figured out why the passenger side window won't auto-up, even though it's configured to do so in NCSexpert? (See attached picture.) It works on the driver's side but not the passenger side. Auto opening works on both sides; as does comfort opening & closing with the remote.
Close the door, roll window down by holding switch, NOT one touch keep holding switch when down for 5 more seconds.
The roll window up by holding switch NOT one touch, keep holding switch when up for 5 more seconds.
Cant hurt.
#504
I have always thought that it had something to do with the jamming protection. Can I get a window motor from an earlier car & put that in? Will that work?
Last edited by cut7; 03-05-2022 at 12:34 PM.
#505
Well, I tried that, it didn't work. Thanks anyway.
#506
Can anyone verify this? It seems correct. Can you get a motor from an earlier car (that would — ostensibly — have the force sensor in it). Would that work?
#507
Can someone read their R53 KMB (Instrument cluster type) module & post the trace file here, please. (Post the text of the entire trace, or a link to the actual trace). The reason I need it is I'm having trouble reading my KMB module, I get an error; everything else reads fine. Preferably someone with a tach & speedo on the steering column & a chrono pack in the center.
Alternatively, if someone is reasonably close to me (that has a car spec'd as mentioned above) I will come to you, read the trace file, & help you code your car for free!
Alternatively, if someone is reasonably close to me (that has a car spec'd as mentioned above) I will come to you, read the trace file, & help you code your car for free!
Last edited by cut7; 03-12-2022 at 09:23 PM.
#509
Can NCS expert set the time instead of using the radio?
I have done a lot of searching on replacing the stock radio with an aftermarket. The only thing that appears to be an issue is you can no longer set the time. I would think with all the functions of NCS, it would be able to do this. I am just not sure which module it would be in.
I have done a lot of searching on replacing the stock radio with an aftermarket. The only thing that appears to be an issue is you can no longer set the time. I would think with all the functions of NCS, it would be able to do this. I am just not sure which module it would be in.
Thread
Thread Starter
Forum
Replies
Last Post
Jose Antonio Romero
Electrical
1
02-21-2015 07:21 AM