When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hello all, I am considering upgrading my turbo. Currently at a Manic stage 2+ tune.
I would like to get a forge intake tube to. What are you all using? I see that the forge has one provision for a ancillary tube so I can connect to the to the valve cover but not one for the other tube?
What are the electrical connections on the factory intake tube?
If I was going to do it all over again, I would get an NM intake - the one that replaces the turbo inlet tube. The NM is the only one that provides resistors for the two heater elements, and provisions for all the vent tube connections.
Thanks . I didn’t know tha NM makes an intake with all the provisions. I have only seen photos that only have 1 vent tube. Are these just old photos on their website?
I bought the CTS Turbo intake and then called NM and they sold me just the resistors for the plugs. CTS sends you a resistor but its literally just a regular wire one that doesn't have the Male plug on it like the NM lol
I bought the CTS Turbo intake and then called NM and they sold me just the resistors for the plugs. CTS sends you a resistor but its literally just a regular wire one that doesn't have the Male plug on it like the NM lol
I paid like 25.00(Give or take a dollar) to NM for the resistor packs and my check engine light should go away!
They call it the PCV heater delete kit I belive.
I paid like 25.00(Give or take a dollar) to NM for the resistor packs and my check engine light should go away!
They call it the PCV heater delete kit I belive.
Do you guys know if the NM provided resistors will work with the Forge Silicone Inlet hose? I'm thinking about going that route to save money for now and can pick up the NM intake later and attach it to the forge hose. I know the NM induction is the ideal solution but a bit pricey.
Do you guys know if the NM provided resistors will work with the Forge Silicone Inlet hose? I'm thinking about going that route to save money for now and can pick up the NM intake later and attach it to the forge hose. I know the NM induction is the ideal solution but a bit pricey.
The resistors will, but you still have to figure something to do with the small vacuum tube that comes off the side, too