Drivetrain Jb+ ver2 installation question
#1
Jb+ ver2 installation question
Hi,
I finally purchased BMS JB+, and assume that it is new version with California environmental sticker on it.
I followed the instruction from BMS, and yes, it takes less 2 minutes to plug into MAF sensor.
But, how do you guys place jb chip under youy hood? It looks like it will vibrate or shake while driving.
For now, I zip-tied to plastic vacuum line.
And I found something looks like clip on female side of JB+.
I wiggled the chip around to find attachable points for this clip.
Does anyonw know the purpose of this clip?
And possibly any recommendation to mount the chip on the engine?
I finally purchased BMS JB+, and assume that it is new version with California environmental sticker on it.
I followed the instruction from BMS, and yes, it takes less 2 minutes to plug into MAF sensor.
But, how do you guys place jb chip under youy hood? It looks like it will vibrate or shake while driving.
For now, I zip-tied to plastic vacuum line.
And I found something looks like clip on female side of JB+.
I wiggled the chip around to find attachable points for this clip.
Does anyonw know the purpose of this clip?
And possibly any recommendation to mount the chip on the engine?
Last edited by bongshi4; 11-03-2017 at 02:47 AM.
#2
#3