My Stebel Nautilus airhorn install, stock location

[CooperT]

I finally figured out how to get the Nautilus installed in the stock location (driver's side).

There's plenty of room down there.


Removed some plastic. Probably could have removed less, but hindsight is always 20/20. Took some fiddling to figure this location out. I need to notch the bumper support some more so the horn sits flush against the back side/more secure.


Where the hole was drilled from the outside.


From the back. Gives general location of where the hole should end up. You can see where you would need to notch the bumper support so the horn sits flush.


Bumper test fitted.


Just need to wire it up using stock connector and some extra bits (that way I can go back to stock if need be. Horn on passenger side will be kept unless I have a problem w/blowing fuses.

Tim C