You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
The hanger orientation is different, I think from 04's onwards. You can either use only 2 of the 4 hangers (some members were doing this with no problem), or have the 2 hangers modified to fit...I would recommend the latter.
Hey Taylor, Glenn at the shop can make it work for you.
thanks for the help AutoXCooper!
yah, i think any shop that can weld can make the Milltek
work on the 04's (i think) onwards...i think even Midas can.
not that im making fun of them or anything, they are muffler
and brake experts but i dont hear many MINI folks using
them.
it's the inner 2 hangers that need to be repositioned
to point sideways. mine are pointing aft.
since i didnt want the next person have to buy a new
gasket i didn't separate the rear section from the mid
pipe, but if you're going to have a shop install it they
can sell u a fresh gasket and so we can take the 2 sections
apart and make it easier to carry.
anyway, if you have a van or something that would be
much perferred. the thing is long and very difficult
to manuver inside the house in tight areas.
