I think I used the wrong terminology. Maybe I should have said wiring harness. I'm planning on leaving the speaker (male) side disconnected and run new wiring to the current speaker locations. If I ever have to get the car back to stock, the original wiring will be in place.
The PXE-H650 has a harness of its own that needs to be wired to the high level input coming from the head unit. So the plan is to create a male side X9331 connector using the wire linked above and solder that to the harness for the H650. Do you think this will work?
The only car audio experience I have is the installation of a new headunit in a 94 Camry about 12 years ago. This forum is a GREAT resource and there is no way I would attempt this install with out its collective knowledge. I'm really excited to start tearing my Clubby apart
Good luck with your test run!
